Wayne-Dalton 46 Manuel du propriétaire télécharger pdf (Page 23)

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

INSTALLATION

Top Section

Hammer

Nail

Power Drill

7/16 Socket

Driver

Tape Measure

Place the top section in the opening

and vertically align with lower sections.

Temporarily secure the top section by

driving a nail in the header near the

center of the door and bending it over

the top section.

Now ﬂip up hinge leaf against section,

fastening center hinges ﬁrst, and end

hinges last. (Refer to Step 6).

When installing a door with a torsion

counterbalance system, vertical

track alignment is critical. Position

ﬂagangle between 1-11/16” (43 mm)

to 1-3/4” (44 mm) from the edge of

the door. Tighten the bottom lag screw.

Flagangles must be parallel to the door

sections.

Repeat for opposite side.

IMPORTANT: THE DIMENSION

BETWEEN THE FLAGANGLES MUST BE

DOOR WIDTH PLUS 3-3/8” (86MM) TO

3-1/2” (89 MM) FOR SMOOTH, SAFE

DOOR OPERATION.

Complete the vertical track installation

by securing the center jamb bracket(s)

and tightening the other lag screws.

Push the vertical track against the

rollers so that the rollers are touching

the deepest part of the curved side of

the track (see illustration). Tighten all

the carriage bolts and nuts.

Repeat for opposite side.

1-11/16” TO 1-3/4”

FLAGANGLE

TOP

SECTION

NAIL

ROLLER

VERTICAL TRACK

ROLLER AGAINST

VERTICAL TRACK

TOP SECTION

DOOR WIDTH

+3-3/8” TO 3-1/2”

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Wayne-Dalton 46 Manuel du propriétaire Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Wayne-Dalton 46