Wayne-Dalton 8850 Manuel d'utilisateur télécharger pdf (Page 22)

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

�

Side Lock

(4) 1/4”- 20 X 7/8” SELF

DRILLING SCREWS

1/8”

Power Drill

7/16” Socket

Driver

Tape Measure

Pull Rope

NO. 6 SCREW EYE

PULL ROPE

BOTTOM BRACKET

PULL ROPE

Install the side lock on the second section

of the door. Secure the lock to the section

with (4) 1/4”- 20 x 7/8” self drilling

screws. Square the lock assembly with

the door section and align with the square

hole in the vertical track. The side lock

should be spaced in approximately 1/8”

from the section edge.

IMPORTANT: SIDE LOCKS MUST BE

REMOVED OR MADE INOPERATIVE IN THE

UNLOCKED POSITION IF AN OPERATOR IS

INSTALLED ON THE DOOR.

NOTE: After completing this step, continue

with step 9 on page 13.

1/8”

DO NOT INSTALL PULL ROPES

ON DOORS WITH ELECTRIC

OPERATORS. CHILDREN MAY

BECOME ENTANGLED IN THE

ROPE CAUSING SEVERE OR FATAL

INJURY.

Measure and mark the jamb

approximately 48” to 50” (1220 to 1270

mm) from floor on the right or left side of

door. Drill 1/8” pilot hole for No. 6 screw

eye. Install the No. 6 screw eye. Tie the

pull rope to the No. 6 screw eye and to

the bottom bracket as shown.

WARNING

Power Drill

1/8” Drill Bit

1 2 ... 17 18 19 20 21 22 23 24 25 26 27

Commentaires sur ces manuels

Pas de commentaire

Wayne-Dalton 8850 Manuel d'utilisateur Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Wayne-Dalton 8850