Wayne-Dalton 8850 Manuel d'utilisateur télécharger pdf (Page 19)

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

INSTALLATION

Position a ladder slightly to the side of

spring so that the winding cone is easily

accessible, yet your body is not in direct

line with the winding bars. Check the

label attached to the spring warning tag

for the required number of complete

turns to balance your door.

PRIOR TO WINDING OR MAKING

ADJUSTMENTS TO THE SPRINGS, ENSURE

YOU’RE WINDING IN THE PROPER

DIRECTION AS STATED IN THE

INSTALLATION INSTRUCTIONS.

OTHERWISE, THE SPRING FITTINGS MAY

RELEASE FROM SPRING IF NOT WOUND

IN THE PROPER DIRECTION AND COULD

RESULT IN SEVERE OR FATAL INJURY.

Alternately inserting the winding bars into

the holes of the spring’s winding cone,

rotate the winding cone upward toward

ceiling, 1/4 turn at a time, until the

required number of complete turns for

your door height is achieved. As the last

1/4 turn is achieved, securely hold

winding bar while tightening both set

screws in winding cone to 14-15 ft. lbs.

of torque (Once set screws contact the

tube, tighten screws one full turn).

Carefully remove winding bar from

winding cone. Proceed to wind the

second spring in the same manner. While

holding the door down, to prevent it from

rising unexpectedly, in the event the

spring(s) were overwound, carefully

remove the locking clamps from the

torsion tube and the vertical tracks.

IMPORTANT: CAUTIOUSLY REMOVE

LOCKING PLIERS FROM THE TORSION

TUBE AND LOCKING CLAMPS FROM THE

VERTICAL TRACKS.

Adjustments from the number of turns

stated may be necessary. If door raises

off floor under spring tension alone,

Reduce spring tension until door rests on

the floor. If the door is hard to raise or

drifts down on its own, add spring

tension. An unbalanced door such as this

can cause garage door opener operation

problems.

Winding Torsion Spring(s)

Power Drill

3/16” Drill Bit

7/16” Socket

Driver

Phillips Head

Screwdriver

APPROVED

WINDING BARS

WINDING

CONE

SPRING

TORSION

TUBE

APPROVED

WINDING BARS

SET

SCREWS

WINDING

CONE

SPRING

TORSION

TUBE

DOOR HEIGHT 400-8

7’0” 7.875

8’0” 8.875

WARNING

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Commentaires sur ces manuels

Pas de commentaire

Wayne-Dalton 8850 Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Wayne-Dalton 8850